Remove Charging Mode
ESC will ignore input from the charging line, scooter will be rideable during charge. Useful for non-official external batteries.

Version spoofing
Makes the version number higher to prevent DRV updates from the Ninebot app.

Compat with newer Mi Scooter models
Fixes error 42 for Mi Scooter 3 and properly displays the lock icon for compatible models. Experimental!

Higher = More power. Too much power is not recommended for battery and motor life.
This value does not affect top speed.
This is your power limit at full battery voltage. The scooter might use more current to compensate for a lower battery voltage.
All selectable ​​values were tested at stock battery voltage and caused no damage to the tested scooters. However, you should select a value considering other factors such as elevated ambient temperatures (e.g. in summer), differences in component quality or battery mods.

36V (default) 48V System Voltage for estimated draw display ONLY - this is not a firmware patch

Estimated draw on Sports mode - Nominal

350

W | Peak

700

W

Sports

25

A
Drive

17

A
Eco

7

A
7A65A

Current limit | Standard: 55A / 32A / Auto

Higher = More power. Too much power is not recommended for battery and motor life.
This is your actual current limit. The scooter won't draw more than provided value.

Sports

55

A
Drive

32

A
Eco (always Drive power limit)

17

A
10A65A

Max speed

Sports

34

Drive

28

Eco

22

5 km/h65 km/h

Always off, speed-based Switchable, register Switchable, brake Always on Direct power control Flat Quadratic Curve type (DPC only)
Instead of speed-based, the throttle will work on a power-based algorithm (like in a thermal engine vehicle).
WARNING: Speed limit is ignored while using DPC.

Current raising coefficient
How fast current will be applied. Affecting speed-based throttle speed up rate.Updated!
Ignored when using DPC!

Motor Start Speed

Minimum speed in km/h before the motor will start.

5

0 km/h10 km/h

Lever virtual limit

115

Minimum phase current

8

A
Maximum phase current

30

A
LessMore

No KERS
The scooter won't start braking on it's own when the motor is not active. You will still have recuperative braking when using the brake lever. Clonk-free.

Current raising coefficient
How fast current will be applied. Affecting brake speed up rate. Updated!

Default Static Reversed Strobe Brake light mode

Brake light flash frequency

No brake light flash on throttle release
The brake light won't start blinking when the motor is not active.

Cruise Control Delay

How many seconds it takes for cruise control to kick in.

5

1 second10 seconds

Disable cruise control beep

Use these patches with full knowledge of what they do.

Stay on when scooter is locked
Disables auto shutdown when the scooter is locked so it stays on forever.

Regular M365 Display
Changes dashboard message type from "Pro" to "Regular" (for 4-dot M365 dashboard only!).

Change ESC<->BMS baud rate to 76800
Only if you use the compatible open source BMS!

Wheel Size
Wheel diameter - inches. Keep default if you have stock wheels. Updated!

Battery voltage limit
If you want to connect a custom battery with a higher voltage.

Disable BMS communication
Remove official BMS data requirement. The BMS UART interface will be disabled.Experimental!